The Sd-10 is a complete stereo audio repeater. It can be used in Store-Casting, Music-On-Hold, Museum, Haunted Attraction, Safety, Industrial or Entertainment applications. Anywhere you need a solid state, high quality audio system that will play for years. The Sd-10 can be dropped right into an audio system in place of a CD player.
Features of the Sd-10 include:
Stand alone stereo playback of standard Mp3 (all data rates) or .WAV audio files (up to 48 K/16 bit).
Up to 255 different AudioFiles can be stored. Capacity is limited only by the size of your flash card.
Two unbalanced -6 dBv RCA line level outputs to feed external amplifiers.
Audio stored on standard MultiMedia (MMC) or Secure Digital (Sd) flash cards.
All configuration is done using a four position dipswitch. No software needed!
Two LEDs show that the unit is alive and accessing the flash card.
Two non-polarized optically isolated trigger inputs with LED indicators. Easily attached to PLCs, pushbuttons, motion detectors, foot pads, IR sensors, alarm systems and other controllers. These inputs can be configured to ramp audio to preset levels or to select and play specific sounds round-robin or randomly. Store-Casting and Music-On-Hold modes can play an announcement between each music track. Triggered SoundFiles can be set to accept or ignore additional requests once started.
A Sturdy aluminum enclosure. Mounts in 2-3/4” Augat Snap Track, or just Velcro or screw it down. It is small enough to mount right on the back of an amplifier or amplified speaker.
Up to two PlayLists available, depending on mode.
Runs on any voltage from nine to twenty-four vdc. The low current draw allows Sd-10s to run from batteries or solar cells where line power is unavailable.
Optional RS-232 serial port can be used to access specific sounds and monitor the status of the Sd-10.
|Input Voltage||12 V|
|Output||12v DC up to 1A|
|Connector type power||2.1mm|